STEF033AJR

STMicroelectronics
511-STEF033AJR
STEF033AJR

Mfr.:

คำอธิบาย:

วัฏจักร:
NRND:
ไม่แนะนำสำหรับการออกแบบใหม่
เอกสารข้อมูลสินค้า:
โมเดล ECAD:
ดาวน์โหลด Library Loader ได้ฟรีเพื่อแปลงไฟล์นี้สำหรับเครื่องมือ ECAD ของคุณ เรียนรู้เพิ่มเติมเกี่ยวกับโมเดล ECAD

มีอยู่ในสต็อก: 4,151

สต็อก:
4,151 สามารถจัดส่งได้ทันที
จำนวนสินค้าที่มากกว่า 4151 อาจถูกบังคับใช้ข้อกำหนดจำนวนขั้นต่ำในการสั่งซื้อสินค้า
จำนวนขั้นต่ำ: 1   หลายรายการ: 1
หน่วยราคา:
฿-.--
ต่อ ราคา:
฿-.--
โดยประมาณ ภาษีศุลกากร:

การตั้งราคา (THB)

จำนวน หน่วยราคา
ต่อ ราคา
฿34.45 ฿34.45
฿24.90 ฿249.00
฿22.49 ฿562.25
฿19.83 ฿1,983.00
฿18.56 ฿4,640.00
฿17.81 ฿8,905.00
฿16.51 ฿16,510.00
ม้วน แบบเต็ม (สั่งซื้อ 5000 จำนวนหลายชิ้น)
฿16.09 ฿80,450.00
฿15.18 ฿151,800.00

แอตทริบิวต์ผลิตภัณฑ์ ค่าแอตทริบิวต์ เลือกแอตทริบิวต์
STMicroelectronics
ประเภทสินค้า: ตัวควบคุมแรงดันไฟฟ้าแบบสลับได้ระหว่างทำงาน (Hot Swap)
มาตรฐาน RoHS:  
Power Distribution
2.5 A
8 V
3.1 V
1 Channel
3.6 A
- 40 C
+ 125 C
SMD/SMT
FlipChip-9
Reel
Cut Tape
No
เครื่องหมายการค้า: STMicroelectronics
แรงดันขาเข้า/แรงดันจ่ายไฟ - สูงสุด: 8 V
แรงดันขาเข้า/แรงดันจ่ายไฟ - ต่ำสุด: 3.1 V
ประเภทสินค้า: Hot Swap Voltage Controllers
ระดับ: STEF033
จำนวนต่อหีบห่อที่ผลิตจากโรงงาน: 5000
หมวดหมู่ย่อย: PMIC - Power Management ICs
น้ำหนักต่อหน่วย: 0.510 mg
ผลิตภัณฑ์ที่พบ:
เลือกกล่องทำเครื่องหมายอย่างน้อยหนึ่งรายการเพื่อแสดงผลิตภัณฑ์ที่คล้ายกัน
เลือกกล่องทำเครื่องหมายด้านบนอย่างน้อยหนึ่งรายการเพื่อแสดงผลิตภัณฑ์ที่คล้ายกันในหมวดหมู่นี้
แอตทริบิวต์ที่เลือก: 0

เอกสารข้อมูลสินค้า

CNHTS:
8542399000
CAHTS:
8542390000
USHTS:
8542390090
MXHTS:
8542399901
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.

STEF033 Electronic Fuse for 3.3V Line

STMicroelectronics STEF033 Electronic Fuse for 3.3V Line is optimized for monitoring output current and input voltage. The STEF033 is connected in series to the 3.3V rail and is able to protect the electronic circuitry on its output from overcurrent and overvoltage. The STEF033 has controlled delay and turn-on time. When an overload condition occurs, the device limits the output current to a predefined safe value. If the anomalous overload condition persists, it goes into an open state, disconnecting the load from the power supply.